Hi there, Diane with you today to share a card I created with
an awesome die 'Tonic Love Arch Squares Die Set'.
This is a beautiful die and all the die cuts you see are from the set.
I first started by cutting the card base using the largest of the dies.
You can see I overlapped it at the top of my folded in half card stock.
It then created the card so it would open and wasn't cut apart.
My next step is a bit different, as I would of normally used
Super Adhesive Sheets but ran out of them.
(I will be ordering them for sure in the near future)
But, to save the day I used Tear-ific Tape 1 1/2"
and covered my die cut with it,
I also used Tear-ific Tape 1/2" on the smaller die cut.
then using Tonic 5" Mini Scissors I carefully trimmed off the excess.
A little more time consuming and a little tricky, but it saved the day!
After the trimming was done, I then added Tooth Fairy glitter.
I love the names of the glitters, I sometimes buy just because of the names!
I did the exact same thing on the larger panel,
but this time used Cloud Nine glitter.
I stamped the flower from Happy Flowers stamp set
then colored with Copics.
The sentiment was stamped with Nuvo Acorn Brown ink
and I die cut a heart (again part of the love arch squares set).
A pretty bow was added to finish.
Thank you for visiting with me today.