Its about Memories..Its about Creation...it's about time

Call us Toll Free

888-901-9173

Butterfly Birthday Wishes by Eret

Hello! It's Eret here to share one simple looking card I made using Sparkle N Sprinkle stamp set named A Big Birthday Wishes Stamp Set #931. It has very cool and bold words in it to make fantastic B-day cards.

Supplies from Sparkle N Sprinkle:
A Big Birthday Wishes Stamp Set #931;
Music Background Stamp Set #427;
Tranquility Microfine Glitter [GM2053];
Hickory Microfine Glitter [GM2044];
Gold Detail Embossing Powder [EP168];
White Detail Embossing Powder [EP298];
Copper Flame Embossing Powder [EP453];
Coffee Embossing Powder [EP459];
Sticker Paper [99558];
1/4" Double Sided Tear-ific Tape [SAT01];
Tonic Monarch & Princess Wings Die Set [1933e];
Nuvo Crystal Glaze [947N];
Nuvo Shimmer Powder - Solar Flare [1210N]
Nuvo Clear Mark Embossing Ink [101N];
Nuvo Deluxe Adhesive [200N];

 

The word 'Birthday' from A Big Birthday Wishes Stamp Set #931 is stamped with Nuvo Clear Mark Embossing Ink on top of the Vellum. I heat embossed it with Coffee Embossing Powder. I used scissors to fussy cut the word. 'Wishes' is also from the same stamp set. It is also stamped with Nuvo Clear Mark Embossing Ink but I used Gold Detail Embossing Powder to heat emboss it. 

I colored piece of watercolor cardstock with Solar Flare Nuvo Shimmer Powder. After it was fully dry, I stamped Music Background Stamp Set #427 on top of it with Nuvo Clear Mark Embossing Ink. I didn't aim for perfect impression, on the contrary, I wanted the stamping to be uneven. I covered part of the stamping with Gold Detail Embossing Powder and rest of it with White Detail Embossing Powder. After heat embossing it with the heat tool, I sprinkled some Copper Flame Embossing Powder here and there and heat embossed it too. Then I used the Glueless Glittering technique (watch tutorial here) to add a sparkle. I dumped some glitter on top of the heat embossing and heated it from underneath the paper. Glitter melted to the embossed pattern and I brushed off excess glitter. 

 

I used Tonic Monarch & Princess Wings Die Set to die cut 5 butterflies out of white cardstock. I adhered one of them to the Sticker Paper. Excess Sticker Paper was cut off and holes inside of the butterfly wings were covered with Tranquility Microfine Glitter. Then I adhered three more die cut butterflies on top of the first one and filled the holes with Nuvo Crystal Glaze. After it was dry, I adhered remaining butterfly on top. 

And as usually, edges of the matting layer was covered with 1/4" Double Sided Tear-ific Tape and Hickory Microfine Glitter

Thank you for the visit!
Eret

Leave a comment

Comments have to be approved before showing up
Sale

Unavailable

Sold Out