Going along with the wreath image from the stamp set, I decided to make a telescopic card, combining the Spellbinders Wreath die set. First, I backed some designer paper with Super Adhesive Sheet. I then ran the two wreath dies through the Tangerine.
The wreaths were each centered on to black cardstock circles, cut from the Spellbinders Grand Circles die set, using the Tangerine. The wreath image was stamped on white cardstock in Nuvo Clear Mark Ink, using the Stamp Platform and then being heat embossed with Black Detail.
Using the Stamp Platform I positioned the sentiment in the middle of the stamped wreath again in Black Detail. The wreath was then colored with Nuvo Aquaflow pens. I made a little palette using an acrylic block and applied the color with a Nuvo Water Brush.
This front panel was then die cut with one of the smaller circle dies with the Tangerine and layered on to the smallest of the black circles (attached with a black brad) with a little piece of white ribbon as a pull at the top. Nuvo Crystal drops Morning Dew were applied to the flowers for dimension.
The middle panel was created by stamping the three birds in Hybrid Black Shadow on top of the scrap piece of the designer paper from one of the wreath cuts and then die cutting the one bird with the circle die.
For the base panel, white cardstock was cut using the inside of the larger wreath die. The birds and the second sentiment were then positioned on the area using the Stamp Platform.
The birds were watercolored using the same palette as before and inserted inside the wreath on the base circle. Nuvo Glitter Drops Sherbert Shimmer were added to the bottom.
The card was assembled bottom to top. Here is the base:
The three panels were then attached with black brads, so that they turn round to close over each other. Here is the entire project closed:
I hope you have enjoyed my share today. Below are the products used in my project:Feathered Friends Stamp Set 909